The highly anticipated V1.2 of the iFlight Blitz Mini F7 E55 2 - 6S 20x20 Stack/Combo is here, now in a sleek Mini version. These new flight controllers are a breeze to set up, with plug and play connectors for your video transmitter, radio receiver, and other periphery sensors.
Explore all our 20x20 stacks and the entire iFlight range!
Features
- • Enhanced circuit design for better performance and reduced electrical noise!
- • DJI HD VTX Connector for easy Plug-and-Play (no soldering needed)
- • FC indicator LEDs for convenient visual debugging
Specifications
- October 20, 2023: Flight control Blackbox flash capacity changed from 16MB to 8MB
- April 6, 2024: The flight control is updated to version V1.2, and the gyroscope is changed from BMI270 to ICM42688.
Flight Controller
- MCU: STM32 F722
- Gyro: ICM42688
- Barometer: DPS310
- OSD Chip: AT7456
- Flash: 8MB (Blackbox flash)
- UARTS: 6
- Motor outputs: 4x (SH1.0 connector)
- I2C serial: SDA / SLA pads
- Smartaudio / IRC Tramp VTX protocol supported
- LED controller: Yes
- Beeper pad: Yes
- Firmware target: IFRC-IFLIGHT_BLITZ_F722
- Mount pattern: 20x20 mm / 4mm PCB hole diameter, silicon grommets for M3 screws
- Dimensions: 30.5x27 mm
- Weight: 5g
Wiring Suggestion
- UART 1 for VTX HD / Analog
- UART 2 for a Receiver
- UART 3/4/5 for GPS or other sensors that require a serial port
- UART 6 for ESC Telemetry
ESC
- Model: E55 V1.3
- Mounting Holes: 20x20mm/µ4mm
- Weight: 11.3g
- Supports 2 - 6S Lipo input
- MCU£º G071
- Constant: 55 Amps
- Burst: 65 Amps
- Current sensor: Yes
- BEC: No
- Current rate: 200
- Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
- Firmware: BLHeli 32
- Target: IFLIGHT_BLITZ_G071_01 32.9
- Firmware: BLHeli 32
Includes
- 1x iFlight BLITZ Mini F7 V1.2 2 - 6S 20x20 Stack/Combo (F7 FC/ E55 V1.3 32Bit 55A 4in1 ESC)
- 1x Silicon grommets
- 1x Wire harness for F7 FC
This iFlight BLITZ Mini F7 V1.2 2 - 6S 20x20 Stack/Combo is perfect for hobbyists and enthusiasts looking for a compact and powerful solution. With dimensions of 30.5x27 mm for the flight controller and 11.3g for the ESC, it's lightweight and easy to install. The 2 - 6S compatibility makes it suitable for a range of applications. Whether you're a beginner or an experienced flyer, this combo simplifies the setup process with its plug and play connectors, allowing you to quickly connect your video transmitter, radio receiver, and other sensors. It's ideal for adding to your RC plane, quadcopter, or other flying models to enhance their performance and functionality.
