RadioMaster RP2 V2 2.4GHz ELRS Nano Receiver - Ceramic Antenna

Note: The packaging in this product will mention V2, however the software is confirmed ELRS V3.

The RP2 is super light & small with a ceramic antenna, perfect for racing! • Built-in WIFI for easy firmware upgrades & configuration via WebUI on PC/mobile. • Low latency & high refresh rate for amazing FPV & long-range flights. This nano receiver fits anywhere and is great for whoops, drones & fixed-wing models! Developed by Jye Smith & the ExpressLRS team, it uses ESP8285 MCU & SX1280 RF chip. The EP2 comes with ELRS Firmware V3 pre-installed and a TCXO oscillator for solid connection & reliability.

Check out the rest of our RC receivers and all our RC transmitters, modules, and accessories!

Features

• TCXO oscillator for a rock-solid connection & reliability.
• Improved PCB design for better heat dissipation.
• LED on the top side of the PCB.
• Solder pads are improved and easier to solder to.
• Open-source receiver based on ExpressLRS
• Upgraded rigid antenna for greater durability and performance

Specifications

• MCU: ESP8285
• Type: ISM
• Antenna: On Board SMT Antenna
• Bus interface: CRSF
• Power input range: 5V
• RF Chip: SX1280IMLTRT
• Maximum receive refresh rate: 500Hz / F1000Hz
• Minimum receiver refresh rate: 25Hz
• Firmware Version: ExpressLRS V3.0 pre-installed
• Signal format: ELRS
• FW Target: RadioMaster RP2 2400 RX
• Size: 13 x 11 x 7mm
• Weight: 0.55g (On Board antenna)

User Manual

• RP2 Receiver User Manual

Includes

• 1 x RadioMaster RP2 V2 2.4GHz ELRS Nano Receiver - Ceramic Antenna
• 1 x User Manual

The RadioMaster RP2 V2 ELRS Nano Receiver is a must-have for RC enthusiasts! Ideal for racing, whoops, drones, and fixed-wing models. With its super light and small design (13 x 11 x 7mm, 0.55g), it fits anywhere. Built-in WIFI allows for easy firmware upgrades and configuration via WebUI on PC/mobile. The low latency and high refresh rate make it perfect for FPV and long-range flights. Developed by Jye Smith & the ExpressLRS team, it uses ESP8285 MCU & SX1280 RF chip, and comes with ELRS Firmware V3 pre-installed.