This AIO is IP67 rated, allowing for submersion in up to 1 meter of water for 30 minutes under ideal conditions.
Unleash the adventure with the brand-new Darwin FPV Hulk AIO! With IP67 water-resistant rating, a 45A BLS ESC, and an onboard ELRS SPI receiver, this AIO is your ultimate drone companion for every escapade!
Check out our other AIO Flight Controllers and Darwin FPV products!
Key Selling Points
- • IP67 Water-Resistant Rating
- • 45A BLS ESC
- • Onboard ELRS SPI Receiver
Specifications
AIO F411
- MCU: STM32F411CEU6
- Gyro: MPU6500
- OSD Chip: Betaflight OSD AT7456E
- Blackbox: 16MB
- UARTS: 5
- I2C: SDA / SLA pads
- LED: Yes
- Beeper: Yes
- Firmware Target: MATEKF405
- FC Mounting Pattern: 30x30mm
- Dimensions: 37x36x10.8mm
AIO ESC
- Input Voltage: 2-6S
- Max. Continuous Current: 45A
- Max. Burst Current: 55A
- MCU: EFM8BB21F16G
- Current Sensor: Yes
- Mounting Dimensions: 25 x 25 M2
- Dimensions 46.2mm x 39.5mm x 10mm
Includes
- 1x Darwin FPV HULK F411/45A 3-6S AIO w/ ELRS 2.4GHz
Please attention:
- Seawater is highly corrosive, it is not recommended for use in seawater. Please wash it with fresh water immediately and then dry it.
- Supports a 3-6S battery, remember not to plug the battery's positive and negative interface in reverse, otherwise, it will burn out.
- After receiving the AIO, first connect to a computer on Betaflight software to check whether the gyroscope and accelerometer are detected and whether the gyroscope attitude is normal.
- Increase the throttle in Betaflight software to ensure the normal rotation and correct rotation direction of the 4 motors, and then install the propellers for a test flight; be sure to remove the propellers when pulling the throttle in Betaflight software to avoid accidents.
- After confirming the above precautions without any problems, you can install the propellers and start flying!
Wiring Diagram
The Darwin FPV Hulk AIO Flight Controller is perfect for drone enthusiasts seeking adventure. With its IP67 water-resistant rating, it can handle submersion in up to 1 meter of water for 30 minutes. It features a 45A BLS ESC and an onboard ELRS SPI receiver. The AIO F411 has an MCU of STM32F411CEU6, a gyro of MPU6500, and more. The AIO ESC supports 2-6S input voltage. It comes with clear usage instructions. Dimensions of the AIO F411 are 37x36x10.8mm and the AIO ESC are 46.2mm x 39.5mm x 10mm. Includes 1x Darwin FPV HULK F411/45A 3-6S AIO w/ ELRS 2.4GHz.
